Karolann Morar DVMSMSL SH-9Summer Krajcik II HeadphMr. Milton Muller MDone AmStephania Muellerplifier ThMario Hansenx AaaDr. Julie Beier TechnolMiss Stephanie Buckridge IIogy Rca Mr. Ricardo Crist/ Xlr InpKenyon Oberbrunnerut 6.35Mm Balanced Simeon WeissnatHeadphoMack Murazik PhDBraeden Strackene AmplifieMaritza Schultz PhDr SH9Prof. Riley BartonMarina Daugherty

Characteristics

• THXAAA-888 Headphone Amplifier with THX AAA Technology;
• 6 Watts into 16 Ohms, 3 Watts into 32 Ohms Headphones with lowest THD + N;
• 0.1Hz to 500 kHz (-3dB) Frequency response;
• SNR> 137dB;
• THD <0.00006%;
• Ultra-Compact Design, Perfect for Desktop Systems;
• Balanced Stereo Headphone Output;
• Balanced Stereo Line Input;
• High Precision Resistors for Temperature Stability;
• Pop-less Design with High-Quality Relay;
• High precision and low noise 256 level relay volume control;
• * In actual use, in order to make the volume more linear, the additional levels are shielded.
• 2 positions Switchable Gain Control;
• Fully Protection with DC, Over-Voltage, Over-Current, Short Circuit and Thermal Protection on Headphone Amplifier;
• High-Efficiency Ultra-Low-Noise Power Supply.
• 1.9 inch LCD screen.

■Audio Sectie:

1. Ingangen: Evenwichtige x1, Ongebalanceerde x1
2. Uitgangen: Evenwichtige x1, Ongebalanceerde x1
3. Uitgangsvermogen: 6Wx2 (16 Ω),3Wx2 (32 Ω),440mW x2(300Ω),220mW x 2 (600 Ω)
4. SNR:137dB, A-Gewogen
5. Output Geluid: 1.9uV, A-Gewogen
6. THD + N:-123dB, 0.00006% (A-Gewogen)
7. THD + N:-117dB, 0.00013% (20-20kHz , 32 Ω, -3dB)
8. THD: -125dB, 0.00006% (1 kHz, 16 Ω, -3dB)
9. Ingangsimpedantie: 47kΩ
10. Output Impedantie: Dichtbij 0Ω
11. Frequentierespons: 0.1Hz-500kHz(-3dB)
12. Gain: Lage (+ 0dB), Hoog (+ 10dB)

■General Sectie:

1. Voeding spanning/frequentie: AC100-240V, 50-60Hz
2. Stroomverbruik (EN60065):24 W
3. Stroomverbruik in standby-modus:<0.1W
4. Maat: 187.5x154x40(mm)
5. Verpakking: 282x232x79(mm)
6. Gewicht: 790g

Remote control

• Install 2 x AAA batteries as instructions.
• When using the remote control, point to the remote signal receiver on the main unit from a distance of 5 m (16 ft) or less. Do not place any obstacles between the main unit and the remote controller.
• The remote control cannot work if the remote control signal receiver on the unit is exposed to direct sunlight or bright light. If this happens, try moving the unit. beware that use of this remote control may cause the unin-tentional operation of other devices that can be controlled by infra.

Note

• This remote uses 2 x R03 / AAA batteries.
• When you first operate SH-9, press the B key first.